We are glad that we can offer the mechanism covers for the Rock-Ola Regis and Empress models again!

Made by vacuum forming like original.
For higher strength - especially at the mounting holes - we used special made material which is slightly thicker than the original material.

The contours had been precise milled. The surface is very smooth. The covers don't need much work or trimming before painting. You only might want to sand some edges.

The holes for the „REGIS“ ornament are already made. If you order a cover for an Empress model the holes still need to be drilled.
The holes for the „120“ ornament are already made. The „200“ fits here too.
The cut-out for the insert on the left side is already milled. We didn‘t do the little slots for the inserts‘ ears (both sides). We think it looks better without when mounted.
Both inserts can be secured with double-sided adhesive tape.
The holes for the “boats” (RO225) are marked but not drilled through yet. Should be done matching the holes in the aluminum plates.

If you use the original aluminium trim plates they have to be shortened at about 2 mm on the lower edges for a good fit (see red lines).
The inserts we offer (RO239) can be mounted directly. Double sided adhesive tape will do the job here as well.

We offer the chrome plated ornaments too (RO216-225). Limited availability.
The holder for the needle brush (RO151) and the brush (V092) are part of our inventory too.

Stock is limited. When all covers had been sold we won't do this item again.